There are certain types of projects that really appeal to me, these projects generally have the biggest impact or affect for the customer and are usually the most challenging. This project was for the Church Of Christ in Mount Vernon, their oil furnace was from 1951 and it was a monster. Time for a upgrade!
Existing Oil Furnace
The furnace was located in the basement in a room about 9′ by 9′ and it consumed most of that room. I had to stand back out of the room just to take a good picture(above). One of the biggest challenges with small community Church’s is the furnace sizing. A lot of small Church’s only get occupied say 1 to 2 times per week and the rest of the time the furnace generally stays off. So you have to consider raising the temperature say from 50 degrees to 70 degrees just for a few hours, and within a short period of time. And of coarse keeping the noise level down. Perfect for the American Standard 95% 2 Stage Variable.
New American Standard 95% 2 stage Variable
One of the complaints from the church was the down stairs is always cold, and even though they had damper controls to help with this issue it never seemed to work correctly, therefore they abandoned that part of the system and went to space heaters. The American Standard 95% Variable 2 Stage furnace with a Honeywell 4″ pleated filter system (above) was installed to deal with just the down stairs, fortunately the existing duct work was zoned to do just that. As you can see the foot print is much smaller than the oil furnace.
Attic Ducting.
Now for upstairs I decided to move the furnace location to the attic, as you can see in the picture above there was plenty of room. This of coarse required some duct modifications.
New American Standard 95% 2 stage Variable
The new American Standard 95% Variable 2 stage furnace and Honeywell 4″ Filter installed like a dream. I had to convert some of the ducting to return while keeping the rest supply air. I also installed a Heat Pump, seeing how they wanted air conditioning I convinced them a Heat Pump is the way to go for added cost savings. As you can see I installed an emergency drain pan under the unit just in case we have a leak. The LP tank you see is for temporary back up heat until we get gas to the building.
New American Standard Heat Pump
Here is the new American Standard Heat Pump, funny how they always seem to match the building color. The refer pipe had to be installed on the exterior of the building and travel up to the attic, so we used a gutter pipe to conceal this piping. Works very well.
New Honeywell Thermostats
And to control the 2 furnaces we installed 1 Honeywell VisionIAQ and a 1 Honeywell VisionPRO 8000. Both the thermostats where located in the mechanical room and both where installed with remote sensors in the occupied spaces. By using remote sensors no unauthorized fingers can adjust the temperature.
Need a Heat Pump, Air Conditioner, Furnace, Boiler or Tankless Water Heater? I install them all over Skagit county including Mount Vernon WA, Burlington WA, Anacortes, Sedro Woolley, La Conner, Stanwood WA, and on Camano Is.
This heat Pump was kinda a head scratcher for me, not because the Carrier Heat Pump we replaced was only 10 years old, but the company that put this in is usually very customer orientated and for some reason let this one fall to the way side. The customer had been having issues with the system since day 1, and for some reason this company could not fix the problem. Maybe the technicians that had been coming out every year after year trying to remedy the problem did not understand air flow …or maybe the head office did not want the burden of dealing with the real problem. Never the less they lost a customer!
Existing Carrier Air Handler
I must apologize for the picture above, I forgot my camera so I must resort to a picture my technician took when we he was called out. Everything he found on the system suggested they where trying workarounds, meaning not dealing with the real issue. The real issue being lack of airflow, the system could not deliver the air needed for the heat pump.
New American Standard Heat Pump
The solution above, an American Standard variable speed air handler. Even though the existing air handler was rated for the job, it could not push the air needed through the existing ducting. BUT this air handler is designed to do just that.
New American Standard Heat Pump
The American Standard heat Pump above is a perfect match for the indoor handler and existing home. The existing refer lines where flushed clean to switch over to the R410a refrigerant.
Alpine Heating And Cooling Vans
Later in the day the sun hit my vans just perfect for a picture. After all it was a perfect day, I gained a happy customer, the customer got a quality matched system with no air flow issues and I got home on time 🙂
Need a Heat Pump, Air Conditioner, Furnace, Boiler or Tankless Water Heater? I install them all over Skagit county including Mount Vernon WA, Burlington WA, Anacortes, Sedro Woolley, La Conner, Stanwood WA, and on Camano Is.
This 80% Rheem was ready for the recycle bin, the customer needed the furnace to be reliable because of their trips away from the home during the winters and this older Rheem was not cutting it. I am surprised it made it this long to tell you the truth.
Older Rheem 80%
The Rheem above was having board issues causing erratic behavior. No sense in throwing good money into a bad piece of equipment.
New American Standard 95% 2 Stage Variable Speed.
Not only is the newer American Standard 95% 2 stage variable speed furnace a quieter piece of equipment, it is a lot more efficient over the Rheem 80%. Now my customer can feel secure in knowing they have a reliable furnace and save some money.
New custom 4″ filter rack
Seeing how there was no access for a Honeywell 4″ pleated filter system because of the venting directly in front of the return ducting, I custom made a 4″ filter frame that is accessible from the side of the unit.
Need a Heat Pump, Air Conditioner, Furnace, Boiler or Tankless Water Heater? I install them all over Skagit county including Mount Vernon WA, Burlington WA, Anacortes, Sedro Woolley, La Conner, Stanwood WA, and on Camano Is.
I really tried to help this customer out, … I even offered without even taking the tarp off to trade for what ever is under that tarp for a new heating system … but some customers want to hold onto their old relics just the same.
Customers Road Runner 67?
This older Heil 90% furnace has seen its last days, the customer made a decision to replace the furnace this year to take advantage of the tax credits and rebates before its to late. Good Choice, the CNG rebated ended 12-31-09
Older Heil 90% furnace
Even though the Heil 90% furnace pictured above looks like a clean install, there are a few things that I should point out. 1) not only is the furnace push up against the wall, it was literally screwed to the wall… making for a great noise transfer system. 2) as pictured below, there was no rail on the right hand side for support or means for sealing.
Existing base can.
Existing base can with new rail
As you can see in the picture above I installed a new rail on the right hand side of the base can. This will give us added support and a place to add sealant.
New American Standard 95% 2 Stage Variable Speed
Here we have the new American Standard 95% 2 Stage Variable Speed furnace. I made sure we had no connection to the wall, eliminating direct noise transfer and replaced 2 transitions on top of the furnace … making for a very clean install. We also connected the existing condensate line to an existing drain line. The existing line just dripped under the home… not good.
Need a Heat Pump, Air Conditioner, Furnace, Boiler or Tankless Water Heater? I install them all over Skagit county including Mount Vernon WA, Burlington WA, Anacortes, Sedro Woolley, La Conner, Stanwood WA, and on Camano Is.
OK … I do not want to scare anyone and or especially any of my customers … BUT if you have a Payne furnace and its just like the model in the picture below .. have us do a safety inspection ASAP. If you’re already one of my customers, chances are we have already done a safety inspection on your Payne furnace … but keep up on your yearly maintenance’s.
1994 80% Payne furnace.
Pictured above is the dead 1994 80% Payne furnace.
American Standard 2 stage 95% variable speed
Here we have the much more efficient American Standard 95% 2 stage Variable speed furnace. I had to raise the unit 8″ to make sure the existing plenum was not blocking of any air flow, then added a transition and filter access door above the unit for easier access. When we finally got done it was 49 degrees … in the home.
Need a Heat Pump, Air Conditioner, Furnace, Boiler or Tankless Water Heater? I install them all over Skagit county including Mount Vernon WA, Burlington WA, Anacortes, Sedro Woolley, La Conner, Stanwood WA, and on Camano Is.
I wish I could have responded sooner, but one of my customers found out their furnace needed to be replaced the day before Christmas. Unfortunately I could not get a furnace until the following Monday, leaving them to rely on their wood stove for heat … I rested a little better knowing they had back up heat.
American Standard 95% 2-stage Variable Speed
Now realize I took this picture just as I was ready to leave, once again almost forgetting to take a picture at all … we had already pushed back the tool box and re-hung the bike from the ceiling. As I took the picture I really did know if i would post it or not … but then I thought it would actually show people how close you can snug things up to an American Standard 95% 2 Stage Variable Speed furnace. This furnace draws its combustion air from the top of the unit, limiting the clearance needed in front and on the sides.
I also want to point out the filter door above the unit, some customers like their current filter setup but want easier access to them. I cut in a simple filter access door that allows the customer to access the filter without reaching into the furnace or removing screws.
Need a Heat Pump, Air Conditioner, Furnace, Boiler or Tankless Water Heater? I install them all over Skagit county including Mount Vernon WA, Burlington WA, Anacortes, Sedro Woolley, La Conner, Stanwood WA, and on Camano Is.
Yet another Rheem 80% being replaced with an American Standard 95%. This unit was getting to costly to repair so the owner decided it was time for a new furnace, good choice. I hate seeing good money being spent on bad equipment.
Older Rheem 80% Furnace Location
It was early and cold when we arrived and I had forgotten to snap a “before” picture before we started, but got a picture just after the unit was removed. What reminded me was seeing the poor seal job the previous installer did on the take offs in the base can.
Existing Base Can.
As the picture shows above, there are gaps around the takeoffs and no sealant used, meaning a lot of hot air escaping into the crawl space. Id say about 50% of the base cans look like this when you pull the furnace. VERY wasteful.
New American Standard 95% Variable 2-stage
And above we have the new American Standard 95% Variable Speed 2 Stage gas furnace installed with a new Honeywell F100 4″ Filter bank On top of it. And yes we sealed the takeoffs before setting the new furnace.
Alpine Heating And Cooling
Need a Heat Pump, Air Conditioner, Furnace, Boiler or Tankless Water Heater? Or a complete heating system? We install them and all over Skagit county including Mount Vernon WA, Burlington WA, Anacortes, Sedro Woolley, La Conner, Stanwood WA, and on Camano Is.
Changing a 80% gas furnace out and replacing it with an American Standard 80% can not get any easier … unless you really enjoy adding the Honeywell F100 4″ Pleated filter bank on to the system, then it takes a little longer.
Older Payne unit
Here you see the older Payne 80% gas furnace. This particular age and model are prone to heat exchanger cracks and should be shut down immediately if found.
New American Standard 80%
If you look under the new furnace in the picture above you will see a new piece ducting. This duct is called a base can transition, this transition allows a wider furnace to be installed on a smaller can, some of the older brands where not as wide. And you will also notice the new Honeywell F100 4″ filter bank added above the new furnace.
Alpine Heating And Cooling
Need a Heat Pump, Air Conditioner, Furnace, Boiler or Tankless Water Heater? Or a complete heating system? We install them and all over Skagit county including Mount Vernon WA, Burlington WA, Anacortes, Sedro Woolley, La Conner, Stanwood WA, and on Camano Is.